support@tdt.com
www.tdt.com
System Set-up.
Before connecting the system
hardware, ensure that the TDT drivers, PC interface, and
RZ and zBus devices are installed, setup, and configured
according to the installation guide provided with your
system.
Connect to power.
Connect the power connector on
the IZ2M/IZ2MH back panel to a mains power outlet
using the provided AC power cable. Using the mains
power switch on the front panel, set to ON to charge the
battery or set to OFF for battery operation.
Connect the stimulator to the RZ base station using the
provided duplex fiber optic cable.
Connect the fiber optic cable from the stimulator’s fiber
optic port labeled Fiber to the fiber optic port labeled
To IZ2 on the back side of the RZ. Use the RED labels to
match up the color coded fiber connectors and be sure
to line up the notch and keys on each.
Connect electrodes.
Connect the DB26 output
connectors on the stimulator to the stimulating
electrodes using your preferred method such as direct
wiring or a custom pass through connector (available
from TDT).
Power on.
Power on the base station, then use the
battery power button on the front panel to power on the
stimulator. The hardware is ready for use.
If using the system with other devices, or preamplifiers,
see the documentation for those devices for hardware
connection information.
Note:
Contact TDT technical support (386-462-9622
or support@tdt.com) before attempting to make any
custom connections to pins 6, 18, or 19.
Mini-DB26 Connector Stim Out Pinouts
Pin
Channel
Pin
Channel
1
1
14
Reserved
2
2
15
GND
3
3
16
GND
4
4
17
Reserved
5
Reserved
18
HSD
6
HSD
19
HSD
7
5
20
6
8
7
21
8
9
9
22
10
10
11
23
12
11
13
24
14
12
15
25
16
13
Reserved
26
Reserved
Synapse Rig Configuration.
The first time the
IZ2M is used, it must be configured in the rig.
When the specialized DSPI card mounted in
the RZ device is detected, an IZ2 will be added
to the rig hardware tree. Click the check box to
the left of the IZ2 icon to enable the device. In
the options area, select the model and number
of channels.
Synapse IZ2M Options.
Click the IZ2M in the Processing Tree to display
and set hardware options.
