POWER
Standard Version:
Power is supplied through Pins 8 (+) and 6 (-) of
the SwitchCraft EN3 Data/Power connector. Allowable input voltage
range is 9-30VDC. Regulation of the input power is not required as
voltage regulation, reverse voltage, over-current and over-voltage
protection circuitry is provided by the SynPaQ/E internal electronics.
Optionally, a reg5V may be supplied to pin 7. Maximum
power consumption of the SynPaQ/E is approximately 1.6W (0.7W
with M12 receiver).
Note: Only one power source may be connected at a time
XTS Version:
The XTS version can accept an unregulated 9-30 Vdc
through pin 8 or a regulated 5 Vdc through pin 6 of the DB-9.
Power/Data common is on pin 7. All other characteristics are identical
to those of the standard version.
USB Version:
The USB version is powered by the USB-VCC. All
other characteristics are identical to those of the standard version.
Resettable fuses are contained in the SynPaQ/E assembly. Since a
resettable fuse is a thermally activated device, if it opens due to
application of excessive input voltage, the unit should be allowed to
cool for several minutes before power is re-applied. Repeated
opening of this device under conditions of proper input power indicate
a probable internal problem, and the SynPaQ/E should be returned to
Synergy Systems for repair.
