Step 5
•
Package the electronics in a similar mannor as
shown
•
Ensure your battery is sitting bellow the EDF,
you should slide it under the rear cover seal
until it is up to half under
•
This will ensure a good position of the centre
of mass for optimal stability and planing
behaviour
•
Please note that the packaging of the
electronics will differ for different electronics,
so the battery place,ent for the optimal centre
of mass may differ too
•
Don’t
forget to unplug the battery
when not
running the HB-02 to prevent the LiPo from
discharging too much, as this will result in the
inability to recharge it
•
Test your electronics,
•
Servo movement, move the servo control and
see the sservo movement
•
Test the EDF by increasing the throttle slightly
and placing your hand behing the EDF
•
You should feel air blowing on your hand, if
you dont then place your hand in front of the
EDF intake, take caution
•
If you feel the air blowing from the back to the
front then you need to reverse 1 of your EDF
to ESC cables; unplug the battery take unplug
1 cables from the ESC and plug them back in
the opposite way;
•
Plug the battery back in and repeat the test;
Step 6
13
