Step 5
•
Prepare the EDF and the hull, remove the
lip of the EDF if it has one.
•
Test fit the EDF in the hull EDF mount by
inserting it from to front of the hull to the
rear, notice how much clearance there is
between it and the mount walls.
•
Take it back out and wrap tape around the
edf; and keep testfitting it until it is a very
snug fit, where force is needed to fit it in
•
Once snug fit the EDF in , ENSURING THE
EDF WIRES ARE FACINGS DOWNWARDS
AT THE REAR.
•
IT IS VERY IMPORTANT THAT YOUR EDF
IS MOUNTED SECURELY, SO PLEASE DO
DOUBLE CHECK
Step 6
•
Prepare parts 7 and the hull with the EDF
mounted
•
Place these in the groove closest to the
EDF (see arrow)
•
To remove your EDF, if you want to use it in
another RC kit, simply pull this stopper out
from the slot in the part
Step 7
•
Prepare the wire extenders
•
Attach wire extenders to your bullet
connectors of the EDF
•
Wrap tape on top of them to ensure they
do not detach -
IMPORTANT
•
Insert the extended EDF wires therough
the oval hole in the hull behind the EDF
•
The EDF is now mounted!
6
