19
20
EN
EN
EN
EN
only single pulses with the desired energy level.
6.
Press the
cartridge activation button on the
applicator to turn on the applicator. Gently position the
applicator on the area you want to treat. Press once the
activation button to emit a single pulse.
7.
Reposition the applicator on the next area to be treated
and press the
activation button again to emit another
pulse. Repeat these previous steps until you have covered
the entire facial area. Wait at least 10 seconds before you
treat over the same spot
.
Without A Face Adaptor
5.
Press the
activation button on the applicator to
turn on the applicator. Gently position the applicator on
the area you want to treat. Upon contact - a pulse will be
emitted. Remove the applicator after a single pulse.
6.
Reposition the applicator on the next area to be
treated, another pulse will be emitted, remove the
applicator after a single pulse. Repeat these previous
steps until you have covered the entire facial area. Wait at
least 10 seconds before you treat over the same spot.
Note:
Always start with LOW
level. If you feel comfortable, you may
increase the
level for better results
clean and store
1.
Turn off the system by pressing the power button on the
base unit.
2.
Place the applicator in its cradle on the base unit and
unplug the electric cable from the electrical outlet.
3.
Clean the cartridge light output window with a non-
alcohol based wet wipe or soft tissue.
4.
If you have used the designated me epilator or shaver:
remove the shaver or epilator from the applicator and
place the protective cap instead. Use a cleaning brush
to clean the accessories. It is recommended to use a soft
tissue or a non-alcohol based wet wipe for cleaning.
5.
If you have used the designated me face adaptor:
remove the face adaptor from the applicator and place
the protective cap instead. Clean the outside surface using
ONLY a dry soft cloth or a non-alcohol based wet wipe.
treating with
3
1
2
6
6.
Clean the outside surface of the me system using ONLY a dry soft cloth or a
non-alcohol based wet wipe.
7.
Store the system in a cool and dry place AWAY from the reach of children.
Gently rinse your skin with lukewarm water and pat dry.
Do not
expose treated areas to the sun. Wait at least 2 weeks after treatment
before you expose treated skin to the sun or tan with artificial light. Even after
2 weeks, make sure that the treated skin is not red from the treatment before you
expose it to the sun. Be sure to carefully protect the treated skin with sunscreen
throughout the hair removal period. Failure to follow this warning could result in
skin swelling, blisters, temporary or permanent skin discoloration or skin whitening
or darkening.
post-treatment care
