11
12
EN
EN
EN
EN
how to use your
system
1.
Clean the cartridge light output window with a non-
alcohol based wet wipe or soft tissue. This is done in order
to remove hairs and dust from the treatment window.
2.
Connect the power cord into the
system.
3.
Place the
system on a table or area near an
electrical wall outlet. Move away any liquids from the area.
4.
Make sure the applicator is placed in its cradle before
turning on the
.
5.
Connect the power cord to the wall electrical outlet.
6.
Press the power button to turn the system on. Wait until
the indicator light on the power button turns green.
Now the system is ready for use.
7.
Set the desired energy level Low, Medium or High.
8.
The cartridge is pre-loaded with pulses for your use
(100%). The cartridge indicator shows the percentage of
pulses remaining as you use the system. When the Empty
button starts blinking, make sure to purchase a new
cartridge. When the Empty button is constantly on, it is
time to replace the
cartridge.
1
setting me up
7
Note:
Start with LOW
level, if you feel comfortable, you may increase
the
level for better results
4
Error
6
skin sensitivity test
If you are using the system for the first time or in new body area, choose a small
area close to the area you intend to treat, for the purpose of performing a skin
sensitivity test. Use the Low
level. Follow the treatment instructions below
but make sure to emit only 2-3 pulses. After the skin test, wait 30 minutes and
check your skin for any reaction. If after 30 minutes the skin appears normal
and there is no redness or other skin reaction, then you are ready to perform a
full treatment.
treating with
Body:
Step 1.
For your convenience, you can use the
epilator or shaver accessories
to remove hair. If you do so, there is no need for preparations before the
treatment, only make sure the hair is no longer than 0.5 cm. Remove the
protective cap, and insert the epilator or shaver cartridge instead.
If you do not use the designated
system shaver or epilator accessories, shave
any hairs with a razor or electric shaver. Make sure that the protective cap
(provided) is inserted. The system will not work if the protective cap or epilator/
shaver accessory is not in place.
Note:
In order to treat blond, grey, red and light brown hair, it is recommended
to use the epilator along with the
cartridge, for better results
High
Level
Medium
Low
7
