EN 13
1. Connect the power cable into the system and then
into the wall electrical outlet. An orange indicator
will appear next to the power button.
2. Before turning on the system, the applicator must be
placed in the cradle. Press the power button to turn the
system on; the elo- s system indicators will flash for
several seconds, then the indicator next to the power
button will turn green.
Now the system is ready for use.
3. Select the elo- s level you want to use by pressing
the appropriate elo- s Level button: High, Medium or
Low; the active level will illuminate a white indicator
light. (Refer to the chart on page 15 of the user
guide to set the right
level for your skin type.)
4. Observe the
cartridge indicator: the elo- s cartridge is pre-loaded with a set number of
pulses for your use; the counter starts at 100% and decreases as you use it. The amount
of pulses remaining in the
cartridge is indicated by the lights on the panel, as shown
in the illustration in the next page. Once the elo- s cartridge reaches 5% of its capacity, a
red light will start blinking, and at 0%, the red light will remain on, indicating that the
cartridge must be replaced, and you should stop using the current elo- s cartridge.
Note: it is safe to use the system untill a constant red light appears near the 0%.
