22 EN
When you are done
Unplug the system from the electrical
wall outlet.
Unless elo- s cartridge is empty, do not
remove it from the applicator. If you remove
the cartridge, insert the elo- s protective
cap in place.
Clean the epilator/shaver cartridge
with the cleaning brush (supplied).
Wipe off the applicator, and the glass
window of the elo- s cartridge in
particular, with soft tissue or non-alcoholic
wet wipes.
Store the applicator back in the base unit.
Store system away from the reach
of children.
Important Note! To ensure long term
performance, it is recommended to clean
the epilator and/or shaver after each use
by using a cotton bud which was first
soaked in alcohol and then squeezed out.
The cotton bud must not be soaking wet,
just moist.
Warning: do not rinse in water any part
of the system.
Important Note! Do not use any
household cleaning agents.
Cleaning the shaver cartridge
1. Turn the system off and unplug the
electrical power cable from the wall
socket.
2. Remove the shaver cartridge by
pressing the release buttons, and sliding
it off the applicator.
3. Remove the foil-covered blade
assembly from the shaver cartridge by
pulling it out.
4. Use the supplied cleaning brush to
clean the blade assembly.
5. Clean the bottom of the shaver
cartridge with the cleaning brush
supplied.
6. Insert the blade foil into the shaver
cartridge again.
7. Put the shaver cartridge back on
again. Push down the shaving head until
it catches.
