Operating Instructions for SM-340H RFID Locker Lock
IDD: +1-604-731-0898
|
info@synometrix.com
|
synometrix.com
4. Lock Functions
a)
Light Indication in Locked Status:
When the lock is locked a red light flashes
every 6 seconds to indicate the lock is in use.
b)
Illegal Card Alarm:
Scan any unauthorized card 6 times and the lock will sound
an alarm for 20 seconds. During the alarm period use an authorized opening card
to terminate the alarm.
c)
Anti-picking Alarm:
If the latch is pressed or picked by force the lock will sound
an alarm for 20 seconds. During the alarm period an authorized opening card will
terminate the alarm.
5. Alarm Functions
a)
Alarm OFF:
In locked status (latch out) scan the owner card near the inductive
area, lights will flash and then press the latch until 2 beeps sound. The alarm
function is now cancelled and set to silent mode.
b)
Alarm ON:
In locked status (latch out) scan the owner card near the inductive area,
lights will flash and then press the latch until 1 beep sounds. The alarm function is
resumed again and set to alarm mode.
c)
Low Battery Alarm:
When the operating voltage is at or below DC 4.5, scan the
opening card, the green light comes on and the lock is unlocked. Music will play to
signal a low battery and the battery must be replaced with a new one.
d)
Emergency Unlocking:
If the battery is completely dead use a 9V battery to
connect to the 2 contacts on the lower part of the front panel and scan the opening
card to unlock the lock.
6. General Specifications
•
Operating Frequency: 13.56 MHz or customized with minimum order quantity
•
Operating Temperature: -15
～
+55
℃
•
Operating Humidity: 20
～
95%RH
•
Supported Standards: ISO 14443 (MIFARE) or custom
•
Power: 3 AA Batteries
•
Light blinks on front of lock when locked
•
Read Distance: Up to 5 cm
•
Housing: Zinc Alloy
•
Lock Outer Ring Dimensions: 45mm diameter
•
Lock Outer Thickness Dimensions: 37 mm
•
Inside Lock Housing Dimensions: 125 mm x 65mm x 20mm
•
Weight: 200g
