Section I
Warnings
006-0007097 02/14/2019
Rev E
5 of 52
UPS-1250DC Guide www.synqor.com
▪ When the battery pack is not inserted into the UPS, the battery is internally disconnected
from the power pins of the battery pack’s connector.
▪ Even if this disconnection were not present, the DC voltage of the battery is below the level
considered hazardous.
▪ Do not apply external voltages to the pins of an exposed battery pack connector. It is not
possible to charge the battery pack from an external source, and excess voltages could
damage internal control circuitry.
Hazardous Energies
The INPUT AND OUTPUT POWER connectors and cables of the SynQor UPS may be the source
of high levels of energy. Do not inappropriately make electrical contact between any terminal of
a connector and another, or between any wire of a cable and another, or between any terminal
or wire and the UPS’s chassis or ground. DAMAGING ELECTRICAL ARCS may result. Care should be
taken to avoid accidental electrical contacts of this sort.
When the BATTERY PACK is not inserted into the UPS, the battery is internally disconnected from
the power pins of the battery pack’s connector. An electrical contact between any two of these
power pins or between any power pin and ground should therefore not be damaging. However,
care should take to avoid accidental electrical contacts of this sort.
