机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller
–
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Z Delta set table
If you have another workpieces need to set do the previous step again.
Many Tool Many Workpieces
Set the Auto Tool number as 3.(left-upper corner)
Set the Tool No. T for the tool you want to align.
Set the feed rate F for the first time alignment and pull back every time.
Please skip to next step setting XY Ref. Coord. Teach if tool alignment equipment already has
fixed mechanical coordinate. If current position is the same with tool alignment equipment,
please set Use Reference as 0.
While setting the XY Ref. Coord. Teach, you will need code "520", enter it and choose yes. These
values will be entered in to Ref coord.X and Ref coord.Y.
Move the cursor to Start Coord. Z, setting the start point for the auto alignment. Press F10 and
then press Z Mach. Coord. Teach, you can insert the current Z coord. values into Start Coord. Z.
Move the cursor to the Min. Z Mach. H, setting the minimum height for the alignment. System will
pop out warning message and stop if the tool is lower than it.
Please switch to auto mode after setting these and then press Start.
After finishing alignment, this tool height value will be saved into Aux. Coord. and External Shift.
Move the tool tip (Manual) to the surface of workpiece, press Z Delta Set, the distance between
alignment tool and workpiece surface will be calculate and set into this workpiece Z coordinate.
Move the tool tip (Manual) to the surface of next workpiece, press Z Delta Set, the distance
between alignment tool and workpiece surface will be calculate and set into this workpiece Z
coordinate.
If you have another workpieces and tools need to set do the previous step again.
Finish alignment.
Tool No. Setting
This Chapter will describe how to set the tool No.
