机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller
–
d.
e.
f.
•
•
•
a.
b.
c.
d.
e.
•
•
•
•
•
•
a.
b.
c.
d.
e.
•
•
•
a.
b.
c.
d.
F2( Continue ): Simulate the machining process
F3( Zoom ): To zoom in/out the simulation. Users can use the arrow key "
←
", "↑", "
→
", "↓" to
move the frame to the expected area, use "PageUp" "PageDn" to zoom in/out this area. After
selecting zoom scales, press "enter" to finish.
F6( Simu. Setting ): Set simulation parameter
5.4.3 Machining Test
MPG Simulation
This chapter is going to introduce how to do machining test with MPG
Condition:
Only for single block( MDI ) and auto mode
Operation:
Press MPG simulation button on operation panel
"Cycle Start"
Turn MPG dial to execute machining
If MPG is turned in CW direction, program will be run from current NC line down to the next NC
line
If MPG is turned in CCW direction, program will be run from current NC line up to the last NC line
Confirm: User could check whether MPG simulation is activated successfully or not with two methods
No "Cycle Start."
After activate MPG function, the G01 percentage in "Monitor" page is zero/nonzero while user
does not/does turning MPG dial
Already "Cycle Start."
After activate MPG function, machine starts decelerating immediately until 0, unless user turn
MPG dial or cancel MPG function.
Single Block
This chapter is going to introduce how to do machining test with single block
Condition:
Only for single block( MDI) and auto mode
Operation:
Press single block button on operation panel
"Cycle Start"
After executing a single block, machine decelerates to 0, state of system is switched to B-stop
Press "CYCLE START" again
After completing next single block in NC file, state of system is in B-stop again
MPG Shift
This chapter is going to introduce the MPG shift function
Condition
Only for single block( MDI) and auto mode
Operation
Press "MPG Shift – Enable" in "MDI" or "auto" mode
MPG shift widow will be displayed
Switch to MPG axis assign
Rotate the MPG and the value will be shown in the MPG shift window
