机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction
–
•
•
•
•
•
•
•
•
•
•
•
•
4.4.5 Operator Panel-F5: Back to Break Point
Press F5, a pop-up show on screen
Press Yes, Change to Break point process mode
Check the focus of the file content is right, and execute.
After finishing this process, go back to operator panel
The status will be changed to next process and go on.
When a unexpected event happen that cause a break to the processing file and you don't wanna do the
whole process again
users can press this button and the system will go back to the block before the break happen, and
continue the working.
Hint: Please DO NOT press the button at normal condition, this might cause the panel process state
to be wrong.
4.4.6 Operator Panel-F6: Clear List
Clear workinglist. No Item will show on workinglist after use this function.
4.4.7 Operator Panel-F7: LogIn
Enter username and password to login to the system
login different users can have different permissions
Permissions can be set in "Authority mangement"
