机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction
–
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
If you want to change the destination device, press F5
「
Device Change
」
, switch the cursor to
the desire device and press
【
Enter
】
, then the below left column data structure will change,
according to the selected device .
Use
【
↑
】【
↓
】
to select file.
Move the cursor to the export file and press F2
「
Select
」
or
【
Space
】
to remark file.
After remarked all of the export file, press F1
「
Copy
」
then all of the remarked file will export
from controller to outer device.
Execute
Command
5 Buttons type: F2 Program
→
F4 File Manager
→
F5 Execute
8 Buttons type: F2 Program
→
F8 File Manager
→
F5 Execute
Function
Execute current program. and also change the screen to the
「
monitor
」
page.
Operation Method
Use
【
↑
】【
↓
】
to select file, and then press
「
Execute
」
the selected file will be the executive
file.
Note
This function is invalid when machining.
Choose DNC File
Command
5 Buttons type: F2 Program
→
F4 File Manager
→
Next
→
F6 Execute
8 Buttons type: F2 Program
→
F8 File Manager
→
F6 Execute
Function
Execute program stored in external devices, such as USB/Network.
Operation Method
Use
【
↑
】【
↓
】
to select file, and then press
「
Confirm
」
the selected file to be executed.
Title of selected file will be showed : DNC + file name
Note
Valid from -
6MDs/6s
：
2.2.0(10.116.10) 11s
：
2.2.1(10.116.10A) 21s
：
2.2.0(10.116.10) 20s
：
10.116.24
When a file reading fail, the control will retry 100 times before pop up a error message
A DNC program must use M30 as the end of program
USB DNC function does not support MACRO function
USB DNC function supports O888800, O999900, and Pr3851=0 functions (after 2.2.5)
When M98, G65, or G66 is used, the subprogram must be stored in controller
4.7 Offset/Setting (MainFenu: F3)
Path
5 key, 8 Key
：
F3 Offset/Setting
10+8 key
：
G3 Offset/Setting
Explanation
Offset/Setting function setup are under this fenubar group
Able to switch between pages in the group with hot key
【
Offset/Setting
】
