机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction
–
•
•
•
•
•
•
•
•
•
a.
b.
c.
d.
e.
Set middle function to mode 1
Different from the manual middle function, user only needs to enter the workpiece dimension
and set the boundary coordinate. After leading the tool to the starting point and press start, the
system will search for the workpiece middle point automatically.
Parameter description
Length I: Workpiece length in X axis direction
Width J: Workpiece width in Y axis direction
Safety Distance H: When the middle function starts, the initial position will be located near the
center of workpiece, while moving from the center to the outer edge of workpiece, descending to
Z axis coordinate P2 and searching for the border, a safety distance is required to avid collision
between the measuring tool and workpiece.
Feedrate F: Detecting speed of auto middle function
Z axis Coordinate P2: This Z axis coordinate is to ensure that the measuring tool is able to contact
the border of workpiece when running auto middle function. It can be set by leading the tool to
P2 and press "Z axis position teach".
Operation method
After setting up following the descriptions, place the tool above workpiece upper surface and
near the center point, distance between the tool and the upper surface should allow the tool to
move freely and not touching the surface. The point will be the starting point of auto middle
function.
Switch to auto mode and press [Start Auto Middle Function] to begin
The system will move the tool and contact the workpiece border according to the set data, the
coordinate values will be shown on the screen. X, Y coordinate of the workpiece center point will
then be calculated.
For controller software versions before 10.116.24x(included), first switch to workpiece coordinate
setting screen, then move cursor to the required workpiece coordinate system and press F3 "Aux.
Coord. Teach", the system will input the Aux. Coord. of the cursor located axis to the column.
For controller software versions above 10.116.34(included), first move cursor to "Workpiece
Coord. No. P" on middle function screen, then input the required workpiece coordinate number
and press F5 "Aux. Coord. Auto Setting", the system will input the Aux. Coord. in X, Y axis direction
to the corresponding workpiece coordinate.
4.7.2 Tool Set
