5 – 6
i
nsTallaTion
/ o
peraTion
/ s
TarT
-
up
©
IT
4000
9.4000.04
1148
j)
Enter the blended water hardness.
Confirm by pressing the MODE ( ) key for at
least 2 seconds.
The blending valve goes into the required
position.
Press the key to get into the main menu.
It allows you to re-enter the salt tank's filling level
(refill salt), trigger a regeneration (regeneration), call
up the salt tank's filling level (Device status), repeat
the start-up (Settings of the device) and to change the
setting of the buzzer and the alarm outlet (Advanced
settings).
Note: Measure the blended water. The following point
"Fine adjustment" might be skipped.
k)
At this stage, it is possible to make a fine
adjustment.
Choose harder or softer water.
Confirm by pressing the MODE ( ) key for at
least 2 seconds.
l)
When starting the device for the first time, trigger
a regeneration cycle to vent the installation.
Confirm with "YES".
If you wish to trigger a regeneration after the
basic settings, select "YES", otherwise select
"NO" to regenerate the IT 4000 at a later stage.
Confirm by pressing the MODE ( ) key for at
least 2 seconds.
m) After these settings, you get into the operation
menu.
It includes an overview of your settings and pro-
vides information on the salt supply.