12
Directions For Use
Installing/Removing Battery from the Control Module
CAUTION:
Do not use batteries if visibly damaged or the Charger
Base indicates a faulty battery.
WARNING:
Do not use the Charger Base, or insert or remove the
Syris battery from the v900L Control Module in an oxygen enriched
environment.
Install the Battery into the Control Module by inserting the battery tabs at the
bottom of the battery into the battery tab pockets of the Control Module. Press
down the blue tab on the top of the Battery and pivot the battery into the
Control Module. Release the blue tab making sure the Battery securely locks
into place. See Figure 3.
To remove the Battery, press down the blue tab and pivot the Battery out of the
Control Module.
Note: After inserting Battery into Control Module, attach Control Module onto
belt. Make sure belt is secure on the body before inserting the L-shaped plug of
the Illuminator Cable into the Control Module as shown in Figure 3.
Status Indicator
Illuminator
Cable Plug
Power / Illumination
Intensity Button (Blue)
Figure 3: Control Module and Battery
Syris Scientific
Blue Tab
