CAN – Ethernet Gateway
10
©
SYS TEC electronic GmbH 2007 L-1032e_9
D-Sub-9
Plug
5-pol.
Signal Name
Description
1 n.c.
not
connected
2
2
CL (CAN_L)
CAN_L bus line
3
1
V- (CAN_GND)
CAN Ground
4 n.c.
not
connected
5
3
SH (CAN_SHLD)
CAN Shield
6
GND
CAN Ground (optional)
7
4
CH (CAN_H)
CAN_H bus line
8 n.c.
9
5
V+ (CAN_V+)
not connected
Table 1:
CAN Connector Pin Assignment
3.2.2
Ethernet Connection
The Ethernet (10Base-T) signals are routed to an RJ45 socket for easy
connection using a standard CAT 3 or CAT 5 network cable. For
direct connection (without a hub or switch) of a CAN-Ethernet
Gateway and a PC, a crosslink cable is required.
The Ethernet connection is galvanic isolated from the CAN-Ethernet
Gateway
Pin
Name
Description
1
TX+
Transmit Data +
2
TX-
Transmit Data -
3
RX+
Receive Data +
4 n.c.
not
connected
5 n.c.
not
connected
6
RX-
Receive Data +
7 n.c.
not
connected
8 n.c.
not
connected
Table 2:
Ethernet Connector Pin Assignment
Summary of Contents for GW-003
