Getting
Started
©
SYS TEC electronic GmbH 2007 L-1032e_9
21
6.
Set the switch 2 "DEFT" to OFF and restart the CAN-Ethernet
Gateway. Upon restart of the CAN-Ethernet Gateway with power-
on or via the command
reset
, the saved configuration file will be
executed and the CAN-Ethernet Gateway will be configured.
/save >reset
↵
7.
Verify the new configuration by inputting the command
ipcfg
(see
Figure 11).
The parameter IP address, subnet mask and standard
gateway stored in the configuration file all correspond to their
settings. Now the Gateway is configured and can be accessed over
the Ethernet (e.g. Telnet).
Figure 11: Verifying the Selected Configuration
This concludes the initial start up of the device.
The CAN-Ethernet Gateway functions with different interfaces
(refer
to section 4.2),
which enable the data exchange over the Ethernet and
CAN. Interfaces are created with the command
mkif
and deleted with
the command
rm
. All created interfaces appear in the folder
/if
. An
interface can be addressed and configured via a direct call to the
directory
(refer to section 4.2.4)
.
Summary of Contents for GW-003
