Software
Support
©
SYS TEC electronic GmbH 2007 L-1032e_9
91
7.3.5.2
Starting the Demo Program
The demo program requires various command line parameters, such as
the IP address and the port number of the Gateway, as well as the
transfer protocol to be used (TCP or UDP). The demo program is
started as follows:
Open a command shell and switch to the folder of the executable file
EthCanDemo.exe
(which was given during installation).
To start the demo program enter the name of the executable program
when given the input prompt, followed by the IP address, the Port
number and the desired transfer protocol. The following shows two
examples:
Example 1:
...\Release\EthCanDemo.exe 192.168.010.111 8234 TCP
Example 2:
...\Release\EthCanDemo.exe 192.168.010.111 8234 UDP
Summary of Contents for GW-003
