12
3 - Transport, Lifting and Positioning (continued)
WARNING
During the lifting and handling of the unit, be
careful not to damage the finned pack of the
coils positioned on the sides of the unit.
The sides of the unit must be protected by
cardboard or plywood sheets.
WARNING
It is recommended not to remove the protective
plastic envelope, that should prevent scraps
from penetrating into the appliance and any
damage to the surfaces, until the unit is ready
for operation.
WARNING
The lifting eyebolts protrude from the base
of the unit; it is therefore recommended to
remove them once the unit has been lifted and
positioned, if in your opinion they are likely to
become a source of hazard and injury.
The eyebolts must be mounted on the unit whenever it shall be
displaced and then lifted again.
3.3 Anchoring
It is not essential to secure the unit to the foundations, unless in
areas where there is a serious risk of earthquake, or if the appliance
is installed on the top of a steel frame.
3.4 Storage
When the unit is to be stored before installation, adopt a few
precautions to prevent any damage or risk of corrosion or wear:
Q
plug or seal every single opening, such as water fittings
Q
do not store the appliance in a room where the temperature
exceeds 50 °C for the units using R410A and, if possible, do not
expose to direct sunlight
Q
minimum storage temperature is -25 °C
Q
it is recommended to store the unit in a roof where traffic is
minimized, to prevent the risk of accidental damage
Q
the unit must not be washed with a steam jet
Q
take away and leave to the site manager all the keys providing
access to the control board
Finally, it is recommended to carry out visual inspections at regular
intervals.
