INSTALLATION AND OWNER’S MANUAL
RTS-W – 20, 40, 60 minutes Wireless Timer
*Compatible with ECO-Touch IAQ Only
OVERVIEW
The RTS-W is a battery operated wireless timer switch that can be
used with an ECO-Touch IAQ wall control to wirelessly activate its
highest ventilation rate for 20, 40 or 60 minutes.
It is designed to fit in a single-gang box and comes with screws to
mount it and a Decora® plate.
INSTALLATION
Battery
This timer comes with a CR2450 battery cell which must be installed in the timer before pairing to the ECO-
Touch IAQ wall control.
Note:
Ensure that the metal pins on the “GND” side of the battery holder sit bellow the battery cell (on the “-“
side) and the metal pins on the “VE” side of the battery holder sit above the battery cell (on the “+” side). Make
sure the metal pins on the “VE” side of the battery holder are not bent flat, they must contact the top of the
battery cell.
Battery Replacement
Over time, the battery will need to be replaced, only replace with CR2450 3V type batteries.
Timer Pairing
This timer can be paired only to a Fantech HRV/ERV via the ECO-Touch IAQ wall control. The timer should be
paired to the ECO-Touch IAQ wall control prior to mounting the timer to the wall in it’s final location.
Pairing steps:
1. Install the battery in the timer as described above
2. Make sure ECO-Touch IAQ is installed in it's final location, properly
connected to the HRV/ERV and powered ON (see ECO-Touch IAQ
installation instructions for more information).
3. On the ECO-Touch IAQ control, press on the "Options" section at
the bottom of the screen then press on "Next" during the initial 5
second countdown sequence to enter the user options.
4. Press on "next" until you enter the pairing screen. The pairing
screen shows the word "pt0" at the bottom where "0" is the cur-
rent amount of paired timers.
Note:
As you pair more timers, this screen will show the current
number of paired timers (ie: pt1, pt2, etc.)
5. While on this screen, press and hold the activation button for 5-10
seconds on the wireless timer you wish to pair to this ECO-Touch
IAQ wall control. No button press is required on the ECO-Touch IAQ
to pair the timer.
Note:
Timers can ONLY be paired while the ECO-Touch IAQ is on the
"paired timer" screen within the options menu.
6. If pairing is a success, the wireless icons will flash on the ECO-
Touch IAQ wall control screen and the count of paired timers will
increase by 1 on the display. Also, the LEDs on the timer being
paired will flash in sequence from 20, to 40, to 60 minutes, and
finally all 3 will flash together once to indicate the pairing is suc-
cessful.
7. Once all timers have been paired, leave the options menu by press-
ing on “Next” until the 5 second countdown screen and let the timer
expire. Timers can only be activated and tested if the ECO Touch
IAQ is not in the options menu.
8.Test the timer in it's final location before permanently installing to
the wall to ensure it is within operational range of the ECO-Touch
IAQ.
Note:
Up to 8 timers can be paired to the ECO-Touch IAQ wall control
at one time.
