Instructions for machinery where these are regularly to be transported |
45
O.4
General disassembly – sharp edges
Pay attention to several sharp edges during dismantling and disposal of the unit. To avoid injury, CE-marked cut-resist-
ant gloves as well as helmet must be used. The measures are described further in the Maintenance, Dismantling and
Disposal Manual.
P
Instructions for machinery where these are regularly to be transported
The subject in the Machinery Directive about machinery that are regularly to be transported does not exist for the Gen-
iox air handling units, because those units are specially made for one intended application.
Q
The operating method to be followed in the event of breakdown. Safe restart.
Use the below mentioned procedure in the event of breakdown or blockage:
• Switch off the power.
• Remove the reason for breakdown or blockage.
• Follow the start-up procedure described in chapter K.
R
Adjustment and maintenance operations
Must be performed by skilled technicians.
In connection with demands for compensation, Systemair must have full and unhindered access to all relevant reporting
on service, repair, modification and use since the unit was transferred from Systemair to a transport company at the
Systemair factory. It is a condition for compensation that maintenance outlined on the following pages has as a mini-
mum been performed.
R.1
Shutdown of the unit to a safe state
Switch the unit to OFF on the control Panel. See the - Operator’s Guide – if the unit was delivered with control system
from SystemairAnnex 13. Switch off the automatic disconnecting device. The automatic disconnecting device are
marked F1 and F3. See the illustration below.
Use the start-up procedure described in chapter K, when the maintenance activities are completed.
output |
