When the button is pressed again, the Active/User/Fault mode
is entered.
5 Communication Interface Functions
5.1 Power-Up and Reset Operation
All remote modules and digital inputs are marked as invalid
after Power-Up. If a new value is received, this value is stored
in the gateway.
To reset the gateway to factory settings and hence clear the
binding with all remote modules:
• Push the Function button and hold it for 30 seconds. The
green LED starts flashing rapidly for 5 seconds.
• If the button is released within these 5 seconds the reset
operation is entered.
• If the button is not released, the LED goes off and the
gateway will go to idle mode.
RS485 Gateway
User Manual
11
Systemair AB
