Page 12
For lifting operations, use only tools and ma-
terial fit for this purpose, in accordance with
accident-prevention regulations.
During the lifting and handling of the unit, be
careful not to damage the finned pack of the
coils positioned on the sides of the unit. The
sides of the unit must be protected by card-
board or plywood sheets.
It is recommended not to remove the pro-
tective plastic envelope, that should prevent
scraps from penetrating into the appliance
and any damage to the surfaces, until the
unit is ready for operation.
The lifting eyebolts protrude from the base of
the unit; it is therefore recommended to re-
move them once the unit has been lifted and
positioned, if in your opinion they are likely
to become a source of hazard and injury.
The eyebolts must be mounted on the unit whenever it
shall be displaced and then lifted again.
3.3 Anchoring
It is not essential to secure the unit to the foundations,
unless in areas where there is a serious risk of earth-
quake, or if the appliance is installed on the top of a
steel frame
Transport, Lifting and Positioning
WARNING
WARNING
WARNING
WARNING
3.4 Storage
When the unit is to be stored before installation, adopt
a few precautions to prevent any damage or risk of
corrosion or wear:
n
plug or seal every single opening, such as water fit-
tings
n
do not store the appliance in a room where the tem-
perature exceeds 50 °C for the units using R410A
and, if possible, do not expose to direct sunlight
n
minimum storage temperature is -25 °C
n
it is recommended to store the unit in a roof where
traffic is minimized, to prevent the risk of accidental
damage
n
the unit must not be washed with a steam jet
n
take away and leave to the site manager all the keys
providing access to the control board
Finally, it is recommended to carry out visual inspec-
tions at regular intervals.
