SYSTIMAX® AirSPEED™ AP542
User Guide
115
6
Performing Commands
•
Introduction to File Transfer via TFTP or HTTP
: Describes the available file transfer methods.
•
Update AP:
Download files to the AP using TFTP or HTTP.
•
Retrieve File:
Upload files from the AP using TFTP or HTTP.
•
Reboot:
Reboot the AP in the specified number of seconds.
•
Reset:
Reset all of the Access Point’s configuration settings to factory defaults.
•
Help Link:
Configure the location where the AP Help files can be found.
To perform commands using the HTTP/HTTPS interface, you must first log in to a web browser. See
Logging into the
HTTP Interface
for instructions.
You may also perform commands using the command line interface. Refer to
Using the Command Line Interface (CLI)
for more information.
To perform commands via HTTP/HTTPS:
1. Click the
Commands
button located on the left-hand side of the screen. The main
Commands
screen will be
displayed.
Figure 6-1
Commands Main Screen
2. Click the tab that corresponds to the command you want to issue. For example, click
Reboot
to restart the unit.
Following a brief introduction to TFTP and HTTP file transfer, each
Commands
tab is described in the remainder of
this chapter.
