USING THE SY-X260BT
1. Switch the ON/OFF button to switch ON the speaker. A red LED indicator will switch on indicating that
the speaker is now ON.
2. Press the MODE button to switch between the different sources available in the device
(BT/MUSIC/RADIO/AUX).
3. Press the VOL +/VOL – buttons in the speaker to increase or decrease the volume. You can also
perform this action with the remote control by pressing the buttons VOL +/VOL –
4. Press the EQ button to choose the desired configuration.
5. Press the
button in the remote control to mute the device. Press it again to activate the sound of
the speaker.
NOTE: The product does not come fully assembled. For this, screw the speaker to the wooden base
with the provided screws. Please follow the steps below.
RADIO MODE
1. Press the ON/OFF button to switch ON the device.
2. Press the MODE button on the speaker or on the remote control until the BLUE LED indicator switches
on, and you will hear “FM TUNING”
3. Press the
button to make an automatic scan of all the FM stations available. Press it again to stop
on a FM station.
4. Press the
button to next FM stations.
5. Press the
button to Previous FM stations.
6. Press the VOL +/VOL – buttons in the speaker to increase or decrease the volume. You can also
perform this action with the remote control
by pressing the buttons VOL +/VOL –
After scanning all the available FM stations, they will be positioned on the device’s memory. You can use
the numeric buttons on the remote control to choose the desired FM station.
Example: Pressing the key numbers 1+0+0+7 the device will tune to the station 100.7
NOTE: To improve the reception, unroll and extend the FM aerial located in the rear part of the speaker.
NOTE: The equalizer modes are not available in Radio mode.
Summary of Contents for SY-X260
Page 1: ......
