LINE-IN MODE
1. Plug one extreme of the 3.5mm cable to the headphone jack on your device.
2. Plug the other extreme of the 3.5mm cable to the AUX IN line-in on the speaker.
3. Press the ON/OFF button to turn on the device.
4. Press the MODE button on the speaker or on the remote control until the BLUE LED indicator switches
on.
5. Use your device volume controls to set the music volume.
NOTE: You will not be able to use the speaker volume controls while there is a device connected to the
line-in.
NOTE: The equalizer modes aren’t available in Line-In mode.
NOTE: You can use the USB connector to charge your Bluetooth device, for this, connect the USB
charger (not included) to the speaker, and the other extreme to the device. Make sure that the speaker
is switched on.
USB/SD MODE
1. Insert a USB stick or a micro SD card in the speaker to playback MP3 music files.
2. Press the ON/OFF button to switch on the unit. Press the MODE button on the speaker or on the
remote control until the BLUE LED indicator switches on.
3. Press the
button to pause the music, press it again to resume.
4. Press the
button to go to the next track. Press the
button to go to the previous track.
5. Use the numerical buttons to select a desired track. For example, pressing 3 + 7 + 4 buttons in the
remote control, the track number 374 will playback.
NOTE: The supported music file format is MP3 (32kbps-320kbds). To play files from a SD card, connect
it when the unit is in standby mode.
NOTE: The files will playback in the same order as they were saved on the SD card. Music placed in
folders cannot be accessed. Therefore, your music needs to be placed in one complete list and not in
folders.
Summary of Contents for SY-X260
Page 1: ......
