38
tube·amp·company
OPERATING THE APPLIANCE
Operation
Button(s)
Description
Switch on and off
POWER (1)
The amplifier is switched on and off using this button at the front panel. It
has no standby option. When switched off the device is internally separa-
ted from the AC power. As a precaution, after switching on, the volume set-
ting of the amplifier (4)(13) should be reduced. After switching on, the
device needs a few seconds before it is ready to operate. Meanwhile, the
loudspeakers are muted and the LED “WARM UP” is on. During power-on
mode, one of the LEDs for the input selection (6) will be lighted.
Select an input
INPUT (6)
Input
Selector
keys (12)
At the front panel: If you turn the dial “INPUT”, you select one of the devi-
ces connected to the inputs on the back of the K-35 (7) for playback.
Using the remote control: A short touch on the button for the desired input
channel (e.g. “S1”) changes to the playback of the audio source connec-
ted there.
The LED associated to the selected input channel will be illuminated at the
front of the appliance. Before switching over the input channel, the volume
(4)(13) should be turned down as a precaution!
Change the volume
VOLUME (4)
VOL+/- (13)
At the front panel: Turn the knob “VOLUME” clockwise to turn up the volu-
me and counter-clockwise to turn it down. Using the remote control: Press
and hold the button “VOL +” to raise ist value. Use “VOL -” to lower the
volume level. The volume setting does never influence the signal at the out-
put “OUTPUT REC” (8).
Mute the loudspeakers
MUTE (11)
The MUTE function can only be activated or deactivated with the remote
control. It switches off the speaker outputs (9) and the recording output
“OUTPUT REC” (8). Pressing one of these buttons again restores the volu-
me to its original setting.
