33
Assigning a Device Address
If the
MP 1260 R
shall be operated in a
system with
R
LINK
or RC control,
it is necessary to assign a device address in the System Configuration menu to
the
MP 1260 R
.
Assigning a device address
•
Open the menu by a brief press on the
-
button on the front panel.
•
With the
/
buttons select the menu item Device Address
•
To change the address first activate this menu item by pressing the
-button, then select the address with
/
-buttons.
You have the choice of the following device addresses:
CD
Tuner
Tape1
Tape2
TV
Aux1
Aux2
Aux3
DVD
STB
VCR
AuxAV1
AuxAV2
DBR
Please select that device address which corresponds to the amplifier input
the
MP 1260 R
is connected to. In most cases the AUX1 address will be the
best choice for the
MP 1260 R
•
After selecting the desired address, please press the
-button again to
store your selection.
•
To leave the menu, please press the
button.
You can leave the menu any time without changing the address assignment by
pressing the
-button.
Activating optional functions
The
MP 1260 R
features the facility to release optional (extra-cost) functions by
entering a four-digit code, such as the gapless function.*
This is the procedure for entering the code:
Activating optional
functions
(code entry)
•
Switch the machine on using the
-button, and immediately
afterwards hold the
button pressed in until the “Software Update
Menu” appears.
•
Use the
button to move the arrow downwards on the screen until
the menu point “Code” is selected.
•
You will now see the message “starting SCL”, followed by “- - - -“ (or an
already activated option; the latter can be overwritten)
•
Activate the input process by pressing the
button.
•
Enter the first point using the
/
buttons.
•
(Optionally using the
to
buttons on the remote control
handset)
•
Press the
button to move to the next point.
•
Repeat the procedure until you have entered the remaining points.
•
To accept the code you have entered, press the
button when you
have finished the data entry process.
•
The screen now displays “starting SCL”.
•
When the code has been verified, you will see a message such as “HDA
ok” for the release of reproduction of high-definition music material at up to
24 bit / 96 kHz.
*
This function may require a software update
You can obtain the code required for the release process by completing an on-
line form, which you will find on the
website
(www.taelektroakustik.de)
in
the Support area under Hardware / Software. You can also contact us by
telephone on [0049] 5221-76760, or by post.
Summary of Contents for MP1260R
