66
CD
playback
stops
or
'jumps'.
Cause 1:
CD damaged or dirty.
Remedy:
Clean CD. A damaged CD cannot be repaired!
Cause 2:
The CD uses a copy protection system which does not conform to the CD-
Audio standard (Red Book Standard)
Remedy:
Take back the CD to the dealer and ask for a proper CD according to the
general CD standard.
Loud humming noise from
the loudspeakers.
Cause:
Poor contact between the Cinch plugs and sockets, or a faulty Cinch cable.
Remedy:
Please check all connections and cables thoroughly.
Streaming Client
The streaming client cannot
connect to a network.
On the display the
indication
Cannot
connect
to
network...'
is displayed.
Cause 1 (cable LAN):
Network cable not properly connected
Remedy:
Connect network cable, check connection to router
Cause 2 (wireless LAN):
WLAN antenna not connected or placed in a location with bad reception quality
Remedy:
Connect WLAN antenna properly and find a location with good reception
quality.
Set the transmission power output of your WLAN router to maximum.
Try to establish a network connection first in a location close to the WLAN
router. If this succeeded try to connect to WLAN from a more remote location.
Experiment with antenna position and try to find a location with better reception
quality.
Cause 3 (wireless LAN):
WLAN reception quality bad (low field strength). Possibly too much attenuated
by walls/ceilings on the transmission path.
Remedy:
Optimize location of receiver and transmitter antennas.
Alternative:
If tr
ansmission problems persist a so called ‚Power Line‘ network might be
good alternative to establish a good and stable network connection.
The best, safest and most secure network however will always be a cable LAN
network.
Cause 4:
Network parameters not properly configured.
Remedy:
Configure the network parameters correctly (see chapter
Cause 5 (operation without network connection):
For proper operation the
MP 2500 R
needs at least one properly connected
network device. This can be a LAN or WLAN network or a USB storage device.
Remedy:
If the
MP 2500 R
shall be operated without network (LAN / WLAN) please
connect at least a USB stick.
The message
'No Data Available'
is displayed
Cause:
The music file on the storage device or on the music server was deleted or the
internet radio station is not available at the moment.
Remedy:
Choose another music title or radio station. If the station or title is not available
any more it should be deleted from the Favourites List (if stored there).
