T+A M 200, User Manual

The operation instructions, the connection guidance 
and the safety notes are for your own good - please 
read them carefully and observe them at all times. 
The operating instructions are an integral part of this 
device. If you ever transfer the product to a new owner 
please be sure to pass them on to the purchaser to 
guard against incorrect operation and possible ha-
zards.

The device is intended to be connected to a mains out-
let with protective earth connector. Please connect it 
only with the mains cable supplied to properly instal-
led mains outlets with protective earth connector. 
The power supply required for this unit is printed on 
the mains supply socket. The unit must never be con-
nected to a power supply which does not meet these 
specifications. 

This device is connected to the power supply as long 
as the power cord is connected.
Even if the device is switched off and the status indi-
cators are dark, the device still carries mains voltage 
inside. To disconnect the device completely from 
mains power supply, the mains plugs must be with-
drawn from the wall socket. Please make sure that the 
mains plugs are easily accessible. Even when the unit 
is in standby mode, it has a low power consumption. If 
the unit is not to be used for a long period disconnect 
it from the mains supply at the wall socket. 

The device is designed to operate in a tem-
perate climate and altitudes up to 2000 m 
above sea level. The range of permissible 
operating temperatures is +10 … +35°C. 
This device is designed exclusively for 
reproducing sound and/or pictures in the 
domestic environment. It is to be used in a 
dry indoor room which meets all the recom-
mendations stated in these instructions. 

Where the equipment is to be used for other purposes, 
especially in the medical field or any field in which 
safety is an issue, it is essential to establish the unit’s 
suitability for this purpose with the manufacturer, and 
to obtain prior written approval for this usage.

If the unit gets very cold (e. g. when being transported), 
condensation may form inside it. Please do not switch 
it on until it has had plenty of time to warm up to room 
temperature, so that any condensation evaporates 
completely.

Before placing the unit on sensitive lacquer or wood 
surfaces please check the compatibility of the surface 
and the unit‘s feet on a non-visible point and if ne-
cessary use an underlay. We recommend a surface of 
stone, glass, metal or the like.  

Please consider the weight of the device. Never place 
the device on an unstable surface; the machine could 
fall off, causing serious or even fatal injury. Many 
injuries, especially to children, can be avoided if the 
following simple safety precautions are observed:
•Use only such items of furniture which can safely 
bear the weight of the device.
•Ensure that the device does not project beyond the 
edges of the supporting furniture.
•Do not place the device on tall furniture (e.g. books-
helves) without securely anchoring both items, i.e. 
furniture and device.
•Explain to children the hazards involved in climbing 
on furniture to reach the device or its controls.

The unit should be set up in a well ventilated dry site, 
out of direct sunlight and away from radiators. The unit 
must not be located close to heat producing objects or 
devices, or anything which is heat sensitive or highly 
flammable.

The ventilation openings must not be covered or clo-
sed. If the system components are to be stacked then 
the device must be the top unit. Do not place any ob-
ject on the top cover. The device is not designed to be 
operated on a soft surface (such as bedding, pillows, 
etc.).

When installing the unit on a shelf or in a cupboard 
it is essential to provide an adequate flow of cooling 
air, to ensure that the heat produced by the unit is 
dissipated effectively. Any heat build up will shorten 
the life of the unit and could be a source of danger. Be 
sure to leave free space of 10 cm around the unit for 
ventilation.

Liquid or particles must never be allowed to get inside 
the unit through the ventilation slots. Mains voltage is 
present inside the unit, and any electric shock could 
cause serious injury or death. Never exert undue force 
on mains connectors.
Protect the unit from drips and splashes of water; ne-
ver place flower vases or fluid containers on the unit.
Do not place naked flame sources, such as candle 
lights on the device.

Safety notes

For your own safety please consider it essential to read these operating instructions right through, and observe in 
particular the notes regarding setting up, operation and safety.

26



