Connections
1
Balanced connections
(XLR)
IN 1
Input for pre-amplifiers with symmetrical outputs.
Connect the XLR socket to the DAC 200 or pre-amplifier pre-out sockets.
OUT 1
Balanced outputs for connecting an additional M 200 power amplifier, e.g. for bi-am-
ping and other purposes.
These sockets provide the audio signal of the preamplifier connected to the balanced
XLR inputs IN1 for pass-through to another power amplifier.
j
You can use the OUT 1 output only if the M 200 is also connected on the input side via
the IN 1 input. Operation in combination with the RCA input IN 2 is not possible.
The M 200 is equipped with two input types (Cinch/RCA and XLR balanced).
Only one connection type can be used at a time. The unused inputs must
remain free.
2
Unbalanced connections
(RCA)
IN 2
Unbalanced amplifier input (RCA jack)
Connect the RCA socket to the RCA output socket of the pre-amplifier.
OUT 2
Unbalanced output for connecting an additional M 200 power amplifier, e.g. for bi-
amping and other purposes.
This socket provides the audio signal of the preamplifier connected to the balanced
XLR inputs IN1 for pass-through to another power amplifier.
j
You can use the OUT 2 output only if the M 200 is also connected on the input side via
the IN 2 input. Operation in combination with the balanced XLR input IN 1 is not possib-
le.
The M 200 is equipped with two input types (Cinch/RCA and XLR balanced). Only one
connection type can be used at a time. The unused inputs must remain free.
This chapter describes all matters of
fundamental importance for installation
and connection which are not relevant
for the daily handling of the device, but
which should nevertheless be read and
observed before first use.
30
Summary of Contents for M 200
