22
Installation
Installing an Expansion Set
To fasten the screws at points B and C, remove the cover of the T-Comfort 930 DSL and insert the screws in
the holes provided for this purpose. The T-Comfort 930 DSL is suspended from the screw at point A, so there
must be a space of 3 mm between the screw and the wall.
Installing an Expansion Set
You can either install the expansion module when you first assemble the system or later as part of a system
upgrade. In both cases, follow the mounting sequence as described here:
1.
Turn off the T-Comfort 930 DSL. Unplug the plug-in power supply from the socket. You should not install
the expansion module or install or uninstall additional interface cards while the T-Comfort 930 DSL is
turned on.
2. Open the housing cover of the T-Comfort 930 DSL. In this case, carefully follow the
Safety Precautions
starting on page 19.
The existing basic module is mounted in the left half of the housing. No components may be mounted in
the right half of the housing.
3. Place the expansion module in the intended mounting location in the right half of the housing. Be sure to
align the 96-pin connector properly to the socket on the basic module. Push the expansion module
towards the basic module so that both modules are securely connected to one another via the 96-pin con-
nector.
Summary of Contents for 930 DSL
