PORTABLE
COLLARING SYSTEM
25
PLUS 115
4. Before engaging the lead screw, it must be
rotated to the full length by hand. Engage the
lead screw onto the collaring head so that the
drive pin of the shank is in the groove of the
lead screw.
5. Lower down the T-65 onto the adapter and
turn the machine counterclockwise, drilling unit
assembly grooves against the stop pins on the
PLUS 115 unit.
(When attaching the T-65 to the PLUS 115
gearbox, note that the T-65 attaches to it only
when the machine is in correct position. The
locking lever on the T-65 is not used for locking,
but instead locking occurs as usual with a
spring-loaded pin on the PLUS 115 unit.
Make sure, that the T-65 machine is properly
attached to the PLUS 115 unit by turning it back
and forth. The T-65 machine should not move).
