I N S T R U C T I O N M A N U A L
20
6.2.2 Fine adjustment of the outlet diameter
NOTE!
Extend the forming pins before adjusting the outlet diameter.
To extend the forming pins (1) press
the conical cover (2) in the direction
of the shank. At the same time twist
the shank (3) clockwise until a
positive stop is reached, and the
forming pins extend. Make a location
mark on the cover and the conical
cover.
Each T-DRILL head is adjusted at the factory to correspond to the nominal
size stamped on the cover of each T-DRILL head. Changing the tube sizes or
the way of joining may require adjustment of the T-DRILL head in order to
achieve the right joint.
Check the forming pin span diameter T
1
2
3
T
Summary of Contents for T-35
