T E E F O R M I N G M A C H I N E
37
T-35
12.3 Maintenance
12.3.1 Loose holder pins
In case holder pins are loose, unscrew both screws on the name plate, lift
up name plate and tighten the set screw for the holder pin with a 3 mm hex
wrench.
12.3.2 Dimple /depth stop are too shallow
The notcher tips in the holder pins are preadjusted at the factory to provide
dimple /depth stop of the proper depth.
In the dimples become too shallow the reason can be loose holder pins.
Check and tighten (point 4.1). If this doesn’t help, put lever in the down
position, turn notcher on its side and tighten the 19 mm nut under the base
plate until it is firmly screwed down.
The indicator that the nut is properly tightened is that the lever stays in the
down position when it is picked up and has to be physically brought to the
up position.
12.3.3 Adjustment of notcher tips
In case notcher tips need fine adjustment do the following:
Heat holder pin with a flame until tips can be turned with 2mm wrench to
the proper depth. Heating is necessary because of glue on tip’s screw.
12.3.4 How to replace lower die
Remove the 19mm nut under the base as follows:
Put lever in down position. Turn notcher on it’s side and loosen the nut.
Noe you can remove screw rod, upper and lower die assemblies, spring
and base from each other.
Lower die has been tightened on the body plate with the help of 4 pieces of
6mm screws. Loosen with a 6mm hex wrench and remove.
Summary of Contents for T-35
