7
Obtaining more steam
(depending on model)
•
Press the
Burst of Steam
button
periodically to remove
stubborn wrinkles (
fig 6
).
Spray Function
•
The
Spray
button
(
fig 7
) will release a mist of water onto your fa-
brics. Use this to remove stubborn wrinkles.
Vertical steam function
(depending on model)
This is ideal for removing wrinkles in delicate garments, jackets, skirts, curtains, etc.:
•
Hang the garment on a hanger and hold the fabric slightly taut with one hand.
•
Set the temperature control dial to
MAX
(
fig 3
).
•
Repeatedly press the
Burst of Steam
button
(
fig 6
) pausing a few seconds
between each push, and continuously move the iron over the fabric (
fig 8
).
•
Hold the iron a few inches from the fabric to avoid burning delicate fabrics.
3-Way automatic shut-off
(depending on model)
The iron is equipped with an electronic system that will automatically cut the
power source to your iron if it is left vertically on its heel for more than 8
minutes, on its soleplate for more than 30 seconds or on its side for more
than 30 seconds.
The auto-off warning light (
fig 9
) will flash when the iron is in the shut-off
mode.
•
To restart the iron, gently shake the iron until the warning light stops
flashing.
Storing your iron
•
Set the steam control lever to
and unplug the iron.
•
Let the soleplate cool completely and empty the water tank. A small amount of water may remain in the water
tank.
•
Wrap the cord around the heel of the iron.
•
Store the iron on its heel (
fig 10
).
Maintenance and cleaning
Cleaning the anti-scale valve
It is recommended that you clean the anti-scale valve once a month to re-
move scale build up on the valve. Clean the anti-scale valve as noted below:
•
Unplug your iron and empty the water tank.
•
Remove the anti-scale valve (
fig 11
).
•
Soak the valve (the black section only) in white vinegar or plain lemon
juice for 4 hours (
fig 12
).
•
Rinse the valve under running water and replace the anti-scale valve in
the iron.
Cleaning the iron
In order to reduce scale build-up and extend the life of your iron, it is recommended that you use the Self-Cleaning
feature once a month, as noted below:
•
Unplug the iron, set the steam control lever to
and fill the water tank to
MAX
.
•
Place the iron on its heel, set the temperature dial to
MAX
, plug in the iron and wait for the indicator light to
go out.
•
Unplug the iron and hold it horizontally over a sink.
•
Remove the anti-scale valve (
fig 11
).
In order to achieve the maximum amount of
steam, it is recommended that you wait a
few seconds after you first push the Burst of
Steam button before pressing it again.
Every fifth time you press the
button, return the iron to the
horizontal position.
The steam is very hot. When
using the ve rtical steam func-
tion, always iron with the
garment on a hanger, never
while wearing it.
When the auto-off warning
light is on, it is normal for the
temperature light to remain
off.
Unplug your iron and let it
cool completely before
cleaning it. The iron will not
function without the
anti-scale valve. Never touch
the end of the valve !
1800124692 FV2280 Q0_110x154 06/01/12 09:11 Page7
