2- DRY IRONING
- Choose your ironing program.
- Set the steam control to DRY (see diagram A).
- You may start ironing when the thermostat light goes out.
ENG
3- CARING FOR YOUR IRON
BE CAREFUL ! Unplug your iron and let it cool down before cleaning it.
“Thermo-Alert” function (depending on model)
- The “Thermo-Alert” light (O) comes on when you choose a program requiring a lower temperature
(for example, changing from program 8 to program 6).
It remains lit while the soleplate temperature is too high.
- When it goes out, you can iron without risk of burning the fabric.
O
• CLEANING THE ANTI-CALC VALVE
(Once per month) :
- Unplug your iron and empty the water tank.
- To remove the anti-calc valve, select program 8, press the release button (P) and pull the valve
upwards.
NEVER TOUCH THE END OF THE VALVE.
- Soak the valve in a cup of white spirit vinegar or plain lemon juice for 4 hours (Q).
- Rinse the valve under running water.
- Replace the anti-calc valve.
THE IRON WILL NOT FUNCTION WITHOUT THE ANTI-CALC VALVE.
• SELF-CLEANING :
In order to extend the life of your iron, use the Self-Cleaning function once a
month.
- Allow your iron to heat up with the tank full and standing on its heel (on program 8).
- When the thermostat light goes out, unplug the iron and hold it in a horizontal position, over a sink.
- Remove the anti-calc valve.
- Shake the iron gently, over the sink, until some of the water in the water tank (with the impurities) has flowed out through the
soleplate.
- At the end of the operation, push the anti-calc valve back into position.
- Turn the iron back on for 2 minutes, setting it on its heel, to dry the soleplate.
- Unplug the iron, and when the soleplate is just warm, wipe it with a soft cloth.
•
CLEANING THE SOLEPLATE :
- While the soleplate is still just warm, clean it by rubbing it with a moist non-metallic pad.
Recommendations :
the self-cleaning function helps to slow down the scaling up of your iron.
P
Q
Summary of Contents for FV92 Series
Page 20: ...047224 23 05...
