11
EN
• To make it easier to use your NutriCook, the Smart Timer
®
is there to help and guide you through your recipes.
• To fit the Smart Timer
®
(C) Fig. 7
, first insert the rear
part, then clip down the front part.
• To remove the Smart Timer
®
(C)
, press the tab and lift it.
Cooking always takes place in two phases:
• The duration of the first pressure phase is directly linked
to the chosen recipe or the kind of ingredients to be
cooked, and this is the time you need to programme on
the Smart Timer
®
using the – and + buttons.
• The second soft cooking phase is pre-programmed into
the Smart Timer
®
and follows on automatically. All you
have to do is follow the guide below...
• You can switch the Smart Timer
®
off at any time by
pressing simultaneously on both buttons.
• During cooking you can change the cooking time only
if the Smart Timer
®
is positionned on the NutriCook.
During the soft steam phase, you cannot modify the
cooking time.
Fitting and removing the timer
Never open your
NutriCook before the
end of the soft cooking
phase, as you could
stop the cooking
process before the
ingredients are fully
cooked. Refer to the
"End of cooking"
heading.
Rear part
Front part
Tab
close
NutriCook
®
NutriCook heats up
select a
programme
programme
the cooking time
turn on the heat,
to full power
0
MAXI
turn down the heat so
there is a constant,
steady release of steam.
0
MAXI
Programmed
time set
Heat source
at max.
Steam is released:
The Smart Timer
(R)
beeps to show that
TBC steam cooking
with pressure is
starting (phase 1)
put in the
ingredients
Heat source
at reduced
Cooking
time
counts down
