3
4. Scope of delivery
The scope of the delivery of this product includes:
One pump with connection cable, one operating manual. Please verify that the scope of delivery is
complete. Depending on the purpose of the application, additional accessories may be necessary
(please refer to the chapters titled "Installation", "Automation with special accessories” and “How to
order spare parts“).
If possible, keep the packing until the warranty period has expired. Please dispose of the packing
materials in an environmental-friendly manner.
5. Installation
5.1.
General installation information
During the entire process of installation, the device must not be connected to the
electrical mains.
This pump is not self, this means that the suction hose and the pump housing must
be completely filled with water constantly, so that the pump can operate.
The pump should be installed in a dry place with an ambient temperature not to
exceed 40 °C and not to fall below 0 °C. The pump and the entire connection system
have to be protected from frost and other climatic influences.
When installing the device, please make sure that the motor is sufficiently ventilated.
The pump should generally be permanently installed for operation. This means that
the pump should be fixed to a suitable, stable and flat support surface with
appropriate screws. To reduce vibration, it is recommended to apply an anti-vibration
material - for instance a rubble layer - between the pump and the installation surface.
With regard to the electrical connection in the case of stationary installation, please
ensure an adequate visibility and accessibility of the plug.
All connection cables must be absolutely tight, as leaking pipes can affect the performance of the
pump and cause significant damage. Therefore densities sure from the threaded portions of the lines
with each other and the connection to the pump with Teflon tape. Only the use of sealing material,
such as Teflon tape ensures that the assembly is airtight.
Avoid when tightening screw excessive force that may cause damage.
5.2.
Installation / Venting the pump
1. There is a suction line including foot valve with non-return valve is urgently needed.
2. The suction pipe must be filled completely with water before installation.
3. Suction line must be bleed - thus completely filled with water.
4. Mount the suction means of Teflon tape completely sealed at the pump.
5. Fill the pump casing completely with water.
6. When all components have been vented and filled with water, the pump is ready for
operation.
In disregard of these installation instructions not smooth operation can be ensured. It
could also lead to significant damage to the pump.
Please observe the illustrations, too, which are contained as an attachment at the end of the present
operating instructions. The numeric and other details included in brackets below refer to these
illustrations.
11
Summary of Contents for GPP 2100 M
Page 106: ...Notizen notes note notas ...
Page 107: ...Notizen notes note notas ...
