FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Toyota LandCruiser 200 Series 2007+
Part No.
070SB13R82A
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia
wide.
File: F-1434.docx
Page 16 of 18
11/12/2013
75.
With the assistance of another person,
carefully lift the FPS into position on the
chassis mount & secure the FPS in place,
using M12 x 1.25 x 40mm hex bolts (6),
1/2" x Ø1-1/4" flat washers (12) & M12
nyloc nuts (6) at the indicated locations.
76.
Adjust the FPS so it is level & that there is a
minimum of 30mm gap between the wings
and vehicle guards then tighten the
fasteners to the appropriate torque settings.
The minimum clearance between the
wings and guards must be maintained to
prevent clashing during off-road driving.
77.
Adjust the headlight trims then tighten the
screws.
The headlight trims must sit forward of
the headlights to prevent clashing during
off-road driving.
78.
Using the indicated hole in the bar mount as
a template, drill a Ø10mm hole through
both vertical mounts in the chassis mount.
79.
De-burr the hole & clean the areas/surfaces
of any swarf/debris, then treat the raw
exposed surfaces with a rust preventative.
80.
Secure through the holes drilled in step 78
using M10 x 1.25 x 30mm hex screws (2),
M10 x Ø30mm flat washers (4) & M10 nyloc
nuts (2).
81.
Tighten the fasteners installed in the
previous step to the specified torque
settings listed on page 1.
LHS SHOWN
