Page 11
Stab servos Installation
Locate the hardware and servo L brackets.
Mock-up and install the L brackets on the
servo as needed to archive proper
direction and (Best Center) position in the
servo pocket. Use medium Thread locker to
secure.
Plug in your servo extension and use heat
shrink or other methods to secure
connection
Build your servo linkage using
1.0”
servo
horns. Use provided ball links and
hardware with threaded control rod. Use
the 35mm threaded rods for Elevators
Center up your servo using a servo
centering device and install servo horn
Locate and install servos using the provided
(SHORT WOOD SCREWS)
Adjust and attach to elevator control horn
and adjust radio as needed to achieve
control throws.
After control setup is complete, remove
ball link from servo horn and install servo
cover using the provided wood screw
Re-attach ball link to control horn and re-
test control throws
