Page 3
The kit will come very well packed.
Carefully remove all the parts from the
bubble wrap that they are encased in. Do
not use a knife or razor as you can
inadvertently cut through the packaging
and damage the finish of the parts. Peel or
use scissors to carefully cut and remove
the tape.
Inspect all parts for any shipping damage
and test fit. Check all packaging, parts and
components. It’s good to organize and
identify hardware and components before
you start the build.
You can use some of the packaging
material to place your air-frame parts on to
keep from damaging or scratching during
your build.
Sometimes the painting process results in a
rough edge that might cause binding.
This
is easily resolved by using a common emery
board to gently smooth the
underside/inside the flight surface and the
top/outside on the control surface
. Use
tape to protect the painted areas on
control surfaces.
Go slow and don’t be too
aggressive with the file to avoid removing
too much material.
Equipment Used (Sold Separately
)
•
Spektrum radio System
•
Demon Cortex Gyro
•
KingTech K210G2
•
KingTech 2X 6.6 3800 Life Packs
•
KingTech 9.9 3800 Life Pack
•
KingTech 150cc UAT with Holder
•
KingTech Smoke Pump
•
PRCJ 6mm Poly Fuel Tubing (6 Feet)
•
PRCJ XXL 36” Smoke Tube
•
PRCJ Large Vents with caps
•
PRCJ T-3 E-Gear Wire Harness (PJ-
T3WHRB)
•
PRCJ T-3 (8) Pack Savox SA1230SG
•
PRCJ Advanced CG Stand
