Page 8
Electric Main Gear Installation.
Feed the main gear and brake wires to the
access area and plug into the wing wire
harness. (Always secure wire connections)
Slide the retract into place and locate the
strut, wheel and brake in the wheel well
making sure that you have equal distances
all the way around the tire and strut as
seen in photo.
When proper location is achieved, mark
holes and drill pilot holes,
NOTE: Use a drill
stop to set drill depths as to not accidently
drill through wing.
Use the (4) provided
screws to mount gear in place. Install gear
cover using provided hardware, slight
trimming may be required for fitment. Use
Aluminum tape to secure brake wires.
Electric Gear Controller Setup.
Each of the three gear units is
independently programmable.
• Long press the mode button to enter
programming mode.
• Short press the mode button to cycle
through the programming options below.
• When the A or B light is blinking, you can
press the + or
–
button to change the servo
direction. This setting is used if the door is
open when it should be closed or vice
versa.
• When the A and B lights are alternating,
pressing the + or
–
will increase or
decrease the servo throw on one end of its
movement. This setting is so that you can
adjust the door to open or close all of the
way without excessive binding at the
extents of motion.
