11
How to program
the toggle switches
(continued)
SETTING UP CONTROL NUMBERS:
There are 2 ways to set up the control numbers for the switches
In the submenu “GLOBAL” (see above), the control numbers for every switch are set in all 120 presets
overall.
In the submenu “INDIVIDUAL” (see above), the control numbers for every switch are only set up in the
chosen preset.
GLOBAL SETUP:
Press the MENU-button and scroll to TOGGEL SW using the >-button. Press the MENU-button again and
it will say CONTROL NR. in the display. Press MENU again and it will “INDIVIDUAL” in the display. Scroll
to submenu “GLOBAL” using the >, < buttons and press the MENU-button. It will say SW 1-------CTRL
NR 20 in the display. Choose switch number using the UP/DOWN buttons, and control number using the
>< buttons.
End the session by choosing QUIT in the submenu and subsequently choosing QUIT in the main menu.
INDIVIDUAL SETUP:
Press the MENU-button and scroll to TOGGEL SW using the >-button. Press the MENU-button again and it
will say CONTROL NR. in the display. Press MENU again and it will “INDIVIDUAL” in the display.
Press MENU again and it will say CTNR 20-------PR 1 and the CTL 1 switch is indicated as being ON. You have
to activate the CTL switch you wish to program, by pressing the actual switch.
To change the control number, use the >,< buttons and to change preset number, use the UP/DOWN
buttons.
End the session by pressing the MENU-button and choose QUIT in the submenus and subsequently choosing
QUIT in the main menu.
SETTING UP TOGGLE SWITCH POSITIONS:
Press the MENU-button and scroll to TOGGEL SW using the >-button. Press the MENU-button again and
it will say CONTROL NR. in the display. Press >- and scroll to POSITION. Press MENU again and it will
say POSITION ----- PR.1 in the display.
Use the UP/DOWN buttons to choose the program number where the switches are to be positioned.
When the desired program number flashes in the right side of the display, activate the control switches
you want to be turned on. The LED above each active control switch indicates the ON/OFF status of the
assigned effects block.
Press the MENU-button to exit. To end the session choose QUIT in the submenu and subsequently choose
QUIT in the main menu
