8
9
STEP 2: Securing the Support Handles
Connect the Signal
Cable
C
(16) and
the Signal Cable
D
(10), and lower the
Left Support Handle
(6) into the pedestal
taking care not to
crimp the cables.
Lock with a screw
(12), and washer
(11). Put the Right
Support Handle (13)
into to the pedestal
and secure it. Be
careful not to lock
the screws to tightly.
STEP 4: Attaching the Control Panel
Remove the plastic
Handle Cover (4) and
connect the Signal
Cable
A
(2) and the
Signal Cable B (5).
Place the Control
Panel (1) on the Left
Support Handle (6).
L o c k t h e p l a s t i c
Handle Cover (4) on
to the Control Panel
(1) with the screw (3).
Finally, lock the Control
Panel (1) onto the Right
Support Handle (13).
Installation
Installation
STEP 1: Setting Up the Base
Tilt the machine base so that the
underside of the base is exposed.
(The serial number should be
visable.) Install the 4 adjustable
feet (18) and place the base feet-
side down.
STEP 3: Connecting the Cross Bar Grip
Affix the Cross Bar Grip
(14) onto the Left Sup-
port Handle (6) with the
screw (9), lock washer
(8), and washer (7).
Do
not tighten at this time
.
Next, secure the Cross
Grip to the Right Sup
-
port Handle in the same
manner. Then, lock all
screws tighlty.