Installation
Operation Instructions
STEP 5: Tightening and Leveling your T-Rex Fit
™
Use the smaller Allen wrench
to tighten the screws (11) at
the bottom of the Left (6)
and Right (13) Support
Handles. Next, use the
larger Allen wrench to
tighten the upper screws
(9) to ensure the cross bar
grip is secured to both
Support Handles, (6) and
(13). Once all screws have
been tightened, carefully tilt
back and roll the machine
to the intended area of use.
(
*Note: For optimal perfor-
mance, it is recommended
the machine be operated
on a hard surface.
)
Finally,
lightly rock the machine
to and fro to determine
whether the adjustable
feet (18) are level. Twist
the feet (18) as neces-
sary until all four feet are
flush with the floor and
the machine no longer
rocks.
Your T-Rex Fit
™
is now
READY TO ROAR!
10
11
Button
Vibration
Mode
Instructions
Time
Speed
START
STOP
Start
Press
START
to turn the machine
on. The machine will be in stand-
by mode until the time is set.
Adjustable Adjustable
Stop
Press
STOP
to end the session.
Time
+
Time
-
Time
Increase/
Decrease
Press
Time Increase/Decrease
to
increase or decrease the time in
increments of 0.1.
Default/
Max time =
10 minutes
Not
Adjustable
Speed
+
Speed
-
Speed
Increase/
Decrease
Press
Speed Increase/Decrease
to increase or decrease the
speed in increments of 0.1.
Not
Adjustable Adjustable
Auto Low
Mode
Selection
Press
Mode Selection
and select:
•
Auto
: Gradually increases
and decreases speed settings
fluctuating between Low,
Med, and High settings.
•
Low:
16.5 Hz
•
Med:
30 Hz
•
High:
40 Hz
Adjustable Adjustable
Med High
3
5
Time
Setting
Press
Time Setting
to set timed
increments of 3, 5, 8, or 10 min.
vibration therapy sessions.
Adjustable Adjustable
8
10
1. Plug the electrical cord into the power connector at the base of the
machine.
2. Turn on the main power switch at the base of the machine.
3. Choose your desired posture on T-Rex Fit
™
, as shown in this Owner’s
Manual.
4. Press the START button to begin your session. Refer to the descriptions
(below) for further instructions.
