T-Rex Twister, User Manual

HERE’S HOW IT WORKS

the main controls on The Twister are the DEPTH, RATE, LEVEL, TONE and 
REGEN knobs, and the CHORUS/FLANGER and LIGHT/HEAVY buttons.

DEPTH determines the degree of modulation, or how heavy your cho-
rus/flange sound is. turn it down for a subtler natural sound, and crank it 
up for a more radical effect.

the RATE knob controls the speed of your twist – from a very slow rotat-
ing sound to a fast, vibrant sparkle.

LEVEL determines the pedal’s overall output volume.

TONE is a unique control that lets you cut back on the high frequencies. 
It’s perfect when you’re looking for a mellower, more vintage sound.

the REGEN (short for “regeneration”) knob is used in flanger mode to 
adjust the amount of feedback you get. turn it up for that unmistakably 
weird feedback flange.

the CHORUS/FLANGER button is where you switch between the two 
twister effects, while the LIGHT/HEAVY button lets you switch between a 
light, airy effect (especially in chorus mode) and a heavier, more drastic 
chorus or flange.

Note: the INPUT LEVEL knob on the side of your Twister eliminates 
overdrive distortion caused by too high an input signal. keep it set just 
below where the red light comes on.

STEREO OUT
The Twister features a stereo output so you can take advantage of all the 
glory of stereo chorus/flange when you’re in the studio or running a ste-
reo live setup. if you think The Twister sounds great in mono, try running 
it in stereo. it will blow your mind!