12
5.2.
Mounting of triangle
T-ROBOT triangle can be mounted and dismounted in a quick way. Follow the below procedures:
1.
Take out the triangle; pay attention to front/rear direction; keep it flat on the base.
2.
Match the front and rear quick-dismantling mechanism; push the triangle from back to front.
3.
When the triangle’s quick connector assembly is connected in position, you will hear a “beep” sound, and then the
clamping bar of quick-dismantling mechanism will eject on.
Fig. 5 Triangle installation diagram
Note:
The triangle must be placed in the correct direction, otherwise it could damage the quick-dismantling
component.
Make sure both the front and back of the triangle enter into the locating pin before sliding it.
In the case of a poor sliding of the triangle, check the quick-dismantling mechanism and quick-dismantling
connector assembly.
After installation of triangle, check if there is any shaking of the triangle and ensure it is installed in position.
5.3.
Dismounting of triangle
1.
Under the shutdown state, park the T-ROBOT steadily on a flat ground; reach the central part of rear bumper
by hand and pull the quick-dismantling spring.
2.
After pulling the spring to the end, push the entire triangle backwards along the base surface.
3.
Wait until the entire triangle slides out of the quick-dismantling mechanism and then lift up the triangle.
